Installation is a little tricky with the controller. The controller has two knobs, one knob can be used to control the rear PSU fan and the other the case fan that was provided in the package. To connect the PSU fan, the PSU has a 2 pin connector which can connect directly into the knob 2 pin connector. If the 2 pin connector is not plugged in, the PSU fan will automatically adjust relying on temperatures. Other than that, if the system is BTX based, using the 20-24pin adaptor cable should resolve the issue.


Design:

Gold plated fan grills and screws, this quality always says it must be a good PSU.

Connectors:

Eight molex connectors and two SATA connectors.

20-24pin adaptor cable for BTX systems.